1、基層應堅實、干凈、大致平整、無明水，基層強度應大于或接近膩子的強度。

1. The base layer should be solid, clean, roughly flat, and free of open water. The strength of the base layer should be greater than or close to the strength of the putty.

2、吸水性強的基層應先用清水潤濕或噴刷膠水進行封底處理后再刮膩子(稠度以適合施工為宜)。3、新抹灰的水泥墻應在養護期后再刮膩子。

2. The base layer with strong water absorption should be moistened with clean water or sprayed with adhesive for sealing treatment before scraping putty (the viscosity should be suitable for construction). 3. Newly plastered cement walls should be putty applied after the curing period.

4、按膩子粉:水=1:0.5的比例攪拌均勻，靜置10~20分鐘再次攪拌均勻即可使用。

4. Mix evenly in a ratio of 1:0.5 putty powder to water, let it stand for 10-20 minutes, and then mix evenly again before use.

5、用鋼刮板或抹刀按常規批刮，刮涂次數不可過多，通常批刮兩次，第二次涂層在前涂層干透情況下方可施工。6、批刮厚度0.8~1.5mm，用量1~1.5kg/m,一般兩遍成活。

5. Use a steel scraper or spatula to scrape in regular batches, and the number of scrapes should not be too many. Usually, scrape twice. The second coating can only be applied after the previous coating is completely dry. 6. The thickness of the batch scraping is 0.8-1.5mm, and the dosage is 1-1.5kg/m. Generally, it is successful after two passes.

7、膩子干后，用320#或240#砂紙進行打磨，盡快涂刷涂料或粘貼墻紙。

7. After the putty is dry, polish it with 320 # or 240 # sandpaper and apply paint or wallpaper as soon as possible.

8、用量:在基層平整的情況下，每公斤膩子粉大約可批0.8—1.2平方米(二批)的平整墻面。

8. Dosage: With a flat base, approximately 0.8-1.2 square meters (two batches) of flat wall can be applied per kilogram of putty powder.

更多的關于濟南膩子粉問題或者詳細的內容，請進入我們公司的網站：http://www.gyxxhyy120.com網站中會有很多的內容僅供參考http://www.jnadx.co

For more information or detailed information about Jinan putty powder, please visit our company's website: http://www.gyxxhyy120.com There will be a lot of content on the website for reference only http://www.jnadx.co